1- Order a physical print:

- Source a local printing company that offers Art prints / Giclée print on white paper (150 to 300gr)
- The JPG source file must be printed at 90cm * 60cm scale.
- Frame the print: I recommend white 15mm wooden framing with 5cm white matte.
- Hang the print on the wall: The vertical center of the print should be at average eyesight (1,60m).

------------------------------------------------

2- Source the video projector:
- You need a regular home video projector around 2000-3000 lumens, with hdmi input.

------------------------------------------------
3- Projector position: suggestions:

There are 3 options to position the projector, the choice of lens depends on this:
1- Projector on ceiling, far away. Long (4:1) or regular lens (2:1) with zoom, position is flexible, about 4m away from print.
2- Projector on ceiling or pedestal, close. Wide lens (0,5:1), projector should be about 1m from print.
3- Projector on ceiling or pedestal below the print: Super wide lens (0.3:1) very close, projector is just above or below print.

Ceiling or pedestal ?
- Projector should be rigged on ceiling just above the top edge of the print (2,10 - 2,50m)
- As an alternative projector can be setup on a pedestal (height around 1m)

------------------------------------------------

4- Setup the video projector

- Make sure the projection covers a little more than the entire print (adjust the zoom).
- The projection area should be as rectangular as possible to minimize distortion.
- Make sure the projection is sharp (adjust the focus).

------------------------------------------------


Setup the software / projection:
- Connect a computer (pc, mac or linux) to the projector with HDMI cable.
- Open the NFT in browser, enable fullscreen on the projector output.
- Right click to remove background image and start mapping.
- Left click to show the 4 red corners on white background.
- Drag each corner of the video to match the corners of the print.
- Fine tune the corners until video matches perfectly.
- Right click to leave edit mode, the video starts on a black background.
- You may adjust/lower the projector's brightness (remote + menu) until the projection appears to be subtle.
- Your projection is ready.

Hold the middle button 3 seconds to reset the mapping corners.